Weider PRO 375 User Manual page 8

10. Press a 60mm Square Inner Cap (55) into each
end of the Top Crossbar (9). Attach the Top
Crossbar to the Uprights (1) using four Joint
Plates (12), eight M10 x 80mm Bolts (41), and
eight M10 Nylon Locknuts (11). Do not tighten
the Nylon Locknuts yet.
Secure the Top Crossbar (9) to the Weight
Guides (18) using two M10 x 30mm Bolts (38)
and two M10 Small Washers (6).
11. Press Carriage Bushings (27) into the ends of the
Weight Carriage (22). Press two 50mm Round
Inner Caps (25) into the ends of the weight tube
on the Weight Carriage.
Insert an M10 x 20mm Bolt (26) into the bracket
on the Weight Carriage (22).
Slide the Weight Carriage (22) onto the Rear
Upright (2) as shown. Make sure that the
Weight Carriage and the Rear Upright are ori-
ented as shown.
12. Refer to the inset drawing. Press a Carriage
Bushing (27) into the top of the Carriage Stop
(28) as shown.
Slide the Carriage Stop (28) onto the lower end of
the Rear Upright (2). Attach the Carriage Stop to
the Rear Upright with an M8 x 70mm Bolt (30)
and an M8 Nylon Locknut (54).
Slide the Rear Upright (2) onto the bracket on the
Rear Base (3). Attach the Rear Upright to the
Rear Base using two M10 x 65mm Bolts (56),
four M10 Small Washers (6), and two M10 Nylon
Locknuts (11). Do not tighten the Nylon
Locknuts yet.
10
38
55
6
41
18
11
2
Weight Tube
25
12
54
11
6
2
8
9
38
6
11
12
12
41
1
18
Angled End
27
22
26
27
28
28
30
56
6
Bracket
3
55
11
1
25
27