Replacing Lasers & Led Worklight - Grizzly T31739 Owner's Manual

Replacing Lasers &
LED Worklight
If either one of the lasers or the LED bulb in the
worklight burn out and need to be replaced, they
must be rewired. A wiring diagram is provided on
Page 36 for your reference.
Items Needed
Phillips Head Screwdriver #1, #2 .................1 Ea.
New Laser & Cord (#PT31739067) ................... 1
Replacing Laser
1. DISCONNECT MACHINE FROM POWER!
2. Remove (2) Phillips head screws securing
burned out laser in laser seat (see Figure 48).
x 2
Figure 48. Location of Phillips head screws
securing laser.
3.
Open belt cover and identify which cord is
connected to laser by lightly tugging cords
fed into headstock (see Figure 49).
Figure 49. Worklight and laser cords fed into
headstock.
Model T31739 (Mfd. Since 11/19)
4. Remove control panel cover. Find where
laser cord wires connect to laser switch and
crimp wire connector (see Figure 50).
Ground
Crimp
Wire Connector
Qty
Laser Cord
(1 of 2)
5.
Remove burned out laser wires from their
their connections on laser switch and in crimp
wire connector, then remove laser from head-
stock, pulling wires with it.
6.
Insert new laser wires up through hole in
headstock, through belt cover, and attach
wires to laser switch and crimp wire connec-
tor as they were connected in Step 4.
7.
Replace control panel cover and close belt
cover.
8. Refer to Adjusting Laser on Page 26 to
secure and adjust laser.
2
E-Stop
Button
3 4
Ground
1 2
1 2
LASER
SWITCH
GORBO
XCK-017
LASERS
DKLD 1801 Laser Switch
Figure 50. Laser wiring.
NC
1
LAY5-
BE102
ON/OFF
Switch
DKLD DZ04
LED LI
1 2
1W 3.5
LIGHT
SWITCH
GORBO
XCK-017
-33-