Bench Mounting; Assembly - Grizzly T31739 Owner's Manual

Bench Mounting

Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed ..
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 7. "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 8. "Direct Mount" setup.
-16-
⁄ "
1
2
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble machine:
1.
Attach column to base using (4) M8-1.25 x 20
hex bolts (see Figure 9).
x 4
Figure 9. Column attached to base.
The headstock is very
heavy. You MUST have
assistance when moving,
lifting, or mounting the
headstock on the column
and base assembly.
2.
Lift headstock and fit it onto top of column
(see Figure 10).
Figure 10. Headstock placed on column.
Model T31739 (Mfd. Since 11/19)