Mounting to
Workbench
Components and Hardware Needed:
To mount the mill to the workbench:
1.
Note: For the best performance, make
sure the cross feed and the longitudinal
handwheels extend out beyond the edge of
the table surface. This will allow unrestricted
handwheel operation.
2.
3.
4.
5.
Figure 7
Mill Base
Workbench
Figure 7.
Qty
Troubleshooting
Before starting the machine, make sure you
have performed the preceding assembly
and adjustment instructions. You must read
through the rest of the manual and under-
stand the various functions and safety fea-
tures. Failure to follow this warning could
result in serious personal injury or even
death!
To test run the machine:
1.
Figure 8
Figure 8.
Test Run
Page 34
OFF