Linhai HY740STL 2018 Service Manual page 82

CHAPTER 3 ENGINE
4. Remove:
⚫Starter one way clutch assembly
1) Hold the generator rotor with a 41mm offset
wrench and remove the starter clutch bolts
2) Remove the one way clutch(1) from the
guide(2).
CAUTION:
Cover the crankshaft end with the box wrench
for protection.
STARTER DRIVE GEAR INSPECTION
1. Inspect:
⚫Starter idle gear teeth
⚫Starter drive gear teeth
⚫Starter torque limiter teeth
Burrs /chips /roughness /wear → Replace.
2. Check:
⚫Starter clutch operation
1) Install the starter driven gear onto the
starter clutch.
2) Turn the starter driven gear by hand to
inspect the starter clutch for smooth
movement. The gear turns
direction only（A）. If a large resistance is
felt for rotation, inspect the starter clutch
or the starter clutch contacting surface on
the starter driven gear for wear or
damage.
3) If they are found to be damaged, replace
the one way clutch with a new one.
⚫Starter torque limiter.
CAUTION:
Do not attempt to disassemble the starter
in one
M750L SERVICE MANUAL 18.0
CHAPTER 3 ENGINE PAGE 3- 51