Table of Contents
Advertisement
TROUBLESHOOTING
CLEANING THE BAR GUIDES
Over time, dust may build up on the Bar Guides (55),
causing a squeaking noise as the resistance system
is used. If this occurs, wipe off the Bar Guides with a
damp cloth and a mild, non-abrasive detergent. Do not
use solvents.
55
ADJUSTING THE RESISTANCE
When the resistance setting changes, the motor will
be heard. To prevent damage to the motor, do not
pull any of the cables while the resistance setting
is changing. If the motor has difficulty adjusting the
resistance level and no cable is being pulled, there
may be too much tension on the upper cable (B).
Adjust the tension as described below.
To decrease the tension on the upper cable (B), turn
the two 3/8" x 1 1/2" Tension Screws (106) twice,
B
106
counterclockwise. Select the desired resistance set-
ting. Repeat this step if necessary.
19
Advertisement
Table of Contents
