Troubleshooting And Maintenance - Weider Pro 2000 User Manual

TROUBLESHOOTING AND MAINTENANCE

TIGHTENING THE CABLES
Woven cable, the type of cable used on the weight
system, can stretch slightly when it is first used. If
there is slack in the cables before resistance is felt,
the cables should be tightened.
Slack can be removed by moving a 90mm Pulley
(34), the Cable Trap (36), and two Finger Guards (35)
to a set of holes closer to the center of the two Pulley
Plates (44). Remove the M10 Nylon Locknut (68) and
the M10 x 52mm Bolt (52) and re-attach the Pulley,
Cable Trap, and Finger Guards to the new set of
holes in the Pulley Plates with the Bolt and Locknut.
Slack can also be removed by moving the 90mm
Pulley (34), the Cable Trap (36), and two Finger
Guards (35) to the higher set of holes in the "U"-brack-
et (43). Remove the M10 Nylon Locknut (68) and the
M10 x 52mm Bolt (52) and re-attach the Pulley, the
Cable Trap, and two Finger Guards to the higher set
of holes in the "U"-bracket with the Bolt and Nylon
Locknut.
Finally, slack can be removed from the cables by tight-
ening the M8 Washer (71) and M8 Nylon Locknut (69)
attaching the Short Cable (47) to the "U"-bracket (43).
The High Cable (not shown) and the Small "U"-bracket
(not shown) can be adjusted in the same manner.
Make sure that the cables are not too tight or the
Top Weight (not shown) will be lifted off the weight
stack.
52
35
36
52
35
20
44
35
68
34
47
43
71
69
68
36
34
35