Weider 831.153971 User Manual page 13

26. Slide the Pad Tube (50) into the Leg Lever (56).
Slide two Large Foam Pads (52) onto the Pad
Tube.
Attach the other Pad Tube (50) to the Leg
Lever (56) and the Leg (5) in the same manner.
27. Attach a 90mm Pulley (40) inside of the Leg (5)
with an M10 x 85mm Button Bolt (92), two M10
Washers (106), two 22mm Spacers (61), and an
M10 Nylon Locknut (103).
28. Wrap a High Cable (101) over a 90mm Pulley
(40). Attach the Pulley to a Pulley Housing (39)
with an M10 x 44mm Button Bolt (93) and an M10
Nylon Locknut (103).
Repeat this step with the other High Cable
(101) and Pulley Housing (39).
29. Make sure that all parts have been properly tight-
ened. The use of the remaining parts will be
explained in ADJUSTMENTS, beginning on the
following page.
Before using the resistance system, turn on
the console and change the resistance setting
as described in CONSOLE OPERATION on
page 18. Refer to TROUBLESHOOTING on
page 21 and adjust the Crossbar Cable ten-
sion as described.
26
52
56
27
103
106
61
40
28
103
13
5 50
50
52
5
61
106
127
39
93
40
101