Adjusting The Weider Pro 335 - Weider 831.150380 User Manual

ADJUSTING THE WEIDER PRO 335

The weight bench is designed to be used with your own weight set (not included). The steps below explain how
the weight bench can be adjusted. See EXERCISE GUIDELINES on page 14 for important exercise information
and refer to the accompanying exercise poster to see the correct form for each exercise. Refer also to the exer-
cise information accompanying your weight set for additional exercises.
Inspect and tighten all parts each time you use the weight bench. Replace any worn parts immediately. The
weight bench can be cleaned with a damp cloth and a mild, non-abrasive detergent. Do not use solvents.
ATTACHING WEIGHTS TO THE WEIGHT CARRIAGE
To use the lat tower, first slide a Weight Stop (45) onto
each side of the weight tube of the Weight Carriage (15).
Slide the desired amount of weight (not included) onto the
weight tube. Be sure that an equal amount of weight is on
each side of the weight tube. Secure the weights on each
side of the weight tube with a Spring Clip (29).
Do not place more than 150 pounds on the Weight
Carriage. (Due to the fact that ab crunches are an aer-
obic exercise, we recommend that you do not place
more than 50 pounds on the Weight Carriage (15) while
performing ab crunch exercises.)
ATTACHING WEIGHTS TO THE LEG LEVER
To use the Leg Lever (28), be sure there is a Weight Stop
(45) on the weight tube. Then slide the desired amount of
weight (not included) onto the weight tube.
Do not place more than 150 pounds on the Leg Lever.
ADJUSTING THE BACKREST
The Backrest (36) can be set at three different positions:
the level position, the decline position, and the incline posi-
tion.
To change the position of the Backrest (36) to either the
incline position or the level position, move the Adjustment
Tube (37) to a different set of adjustment brackets on the
Left and Right Uprights (42, 43). Set the Backrest (36)
onto the Adjustment Tube.
To change the position of the Backrest (36) to the decline
position, remove the Adjustment Tube (37). Set the
Backrest (36) onto the Bench Frame (33).
45
29
Weight
36
42
12
Weight
45
29
15
Weight
Tube
28
Weight
45
Weight
Tube
43
37
Adjustment
Brackets
33