Weider 831.150302 User Manual page 9

8. Orient the Backrest (13) as shown. Attach the
Backrest to the Backrest Tubes (12) with four M6
x 40mm Bolts (27) and four M6 Washers (36).
Attach the tether on the Adjustment Pin (25) to
the Bench Frame (1) with an M4 x 16mm Screw
(45). Insert the Pin through the Bench Frame and
the Backrest Bracket (10).
Tighten the four M6 Nylon Locknuts (40) used
in step 6.
9. Orient the Seat (14) as shown. Attach the Seat to
the Bench Frame (1) with four M6 x 16mm
Screws (37).
10. Slide a Pad Tube (19) into the square hole in the
Front Leg (2). Slide two Foam Pads (20) onto the
Pad Tube. Make sure the Foam Pads are ori-
ented as shown.
Repeat this step with the other two Pad Tubes
(19) and the Leg Lever (3).
11. Attach the Curl Pad (15) to the Curl Post (11) with
two M6 x 16mm Screws (37).
12. Make sure that all parts are properly tightened
before you use the weight bench. The use of
all remaining parts will be explained in ADJUST-
MENTS, beginning on the following page.
8
Wide
End
36
27
10
1
27
9
14
Wide
End
10 20
2
3
19
19
11
15
9
13
12
36
36
25
45
36 27
1
37
37
19
11
37
20