American Standard SELECTRONIC 6053.193 Installation Instructions Manual page 10

F
GENERAL CLEANING; Fig. 5
1. Only use a damp, soft cloth to clean the spout and
the sensor.
2. For tougher dirt, use a soft cloth with diluted dish
washing detergent. Wipe the area using a wet cloth.
Do not scratch the sensor when cleaning. Avoid using
CAUTION
any abrasives or harsh detergents or chemicals.
FAQ'S
Q: How will I know if the battery needs to be replaced?
A: Valve will not open and sensor will continuously blink 2 times interrupted by a pause, for up to 7 days.
Q: Why has the flow rate of the faucet reduced significantly?
A: The filter assembly, flow regulator or areator/spray may be clogged. Check and clean. Refer to Start-up/
Mainenance, sections C, D and E.
Q: Why doesn't water flow out of faucet when I'm within the sensor detection zone?
A: Battery may need replacement. If sensor continuously blinks 2 times interrupted by pause, replace battery
or call (844) CRT-TEAM / (844) 278-8326.Z
Q: What is the normal operating pressure range?
A: Faucet will operate with supply pressures ranging from 20-80 psi.
© 2019 AS America Inc.
Fig.6
10
M965651 Rev. 2.0 (3/19)