ZANKER KBA23022SK User Manual page 19

Table of Contents

Advertisement

Available languages

Available languages

Problem
There is too much condensed water
on the rear wall of the refrigerator.
Door does not open easily.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
Caution! Disconnect the plug from the
mains socket.
1. With your fingers, spread slightly both sides of the
transparent cover to unhook them and detach the
cover pulling it in the direction of the arrows.
The door has been opened often.
There is no cold air circulation in the
appliance.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
You attempted to re-open the door
immediately after closing.
1
2
1
Possible cause
2. Replace the lamp with the one that has identical
characteristics and is specifically designed for
household appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to assembly
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
Solution
Open the door only if necessary.
Make sure that there is cold air cir-
culation in the appliance.
Open the door only when necessa-
ry.
Make sure the door is closed com-
pletely.
Wrap food in suitable packaging be-
fore storing it in the appliance.
Wait a few seconds between closing
and re-opening of the door.
19

Advertisement

Table of Contents
loading

Table of Contents