Table of Contents
Advertisement
Entering AT commands
4
Entering AT commands
Enter PIN first
Working with a
terminal program
Page 26 of 31
The device is controlled via AT commands that are transmitted to it
either by the connected application or by manual entry via a
terminal program, e.g. HyperTerminal.
Please enter the PIN first before any other AT commands. Until a
PIN has been entered most AT commands will be answered with
ERROR.
To be able to control the device directly via AT commands, use a
terminal program, e.g. HyperTerminal.
Note the following settings:
Make the connection:
Speed:
Data bits:
Parity:
Stop bits:
Duplex:
Enabling/disabling local echo
To see your entries on the screen, you may have to enable the local
data echo. To do so, enter the following command: ATE1
To disable the local data echo, enter the following command: ATE0
via the TAINY GMOD-T1 driver
or
directly via the COM port to which the
device is connected
57600 bps
8
(No)
1
(Full)
TAINY GMOD-T1
Advertisement
Table of Contents
