Table of Contents
Advertisement
2.5
Setting up the dial-up connection (under Windows)
Purpose of the
dial-up
connection
Not necessary for:
Set up the dial-up
connection
TAINY GMOD-T1
In order to be able to establish a GPRS connection using the PPP
(Point to Point) Protocol you must set up a dial-up connection
under Windows.
The PPP Protocol is used, for example, for dial-up connections to
the Internet or to a private network which uses the IP Control
Protocol (IPCP). It facilitates the transport of IP data packets via a
PPP connection.
It is not necessary to set up a dial-up connection for
• data transfer, e.g. by terminal program
• fax transmissions
• SMS (Short Message Service)
The following instructions show dialogue boxes that are displayed
when setting up a dial-up connection under Windows XP. If you are
using a different Windows version (Windows 2000), proceed
accordingly.
Under Windows 2000 or Windows XP you must be registered as
the administrator.
Requirements:
You have installed the modem driver (see page 13)
Follow the instructions below and those on your screen:
1. Click on Start, Control Panel.
Consequence:
The Control Panel dialogue box is displayed.
Where required, Switch to classic view.
Double-click on Network Connections.
Consequence:
The Network Connections dialogue box appears.
Click on Make New Connection.
Putting the device into operation
Seite 17 von 31
Advertisement
Table of Contents
