Weber Summit 475 Step-By-Step Manual page 7

ADD COOKING MODULE
Caution: Use two people to lift and install the
cooking module.
Lift the cooking module out of the packaging. The gas line
will hang below the module.
Lower the module on an angle into the sleeve so the
control panel is under the front top rail. Figure 7. Guide
the gas line through he access hole in the sleeve while
lowering the module.
Front
rail
Lower the back of the cooking module down so it sets on
the rear rail. Figure 8. Be careful not to scratch the paint
of the cooking module when installing the module.
The cooking module should be level, setting on the front
and rear rails.
Front rail
Flange
View from
Figure 7
Flange
View from
Figure 8
MOUNT REGULATOR
BRACKET
We recommend that you install the regulator to a rigid
structure. The regulator mounting bracket can be used to
mount the regulator to the built-in structure.
The gas line from the manifold is long enough to reach
the mounted regulator. We have provided the means to
make an SAE flare connection. Do not use pipe sealant
on this connection.
right
Rear rail
right
7