Advertisement
Connecting T1/E1 cables
Patch Panel cables
The patch panel cable connects the interface modules with the patch panel.
Each cable connects one VHDCI connector on the interface module to the connector on the patch panel. A
set of three cables is required to connect one interface module to one 48-port patch panel.
The following table shows details of the patch panel cables:
Patch Panel Cable
CABLE-16TDM-C
CABLE-16TDM-C-R is not supported in Cisco IOS XE Release 3.18.06v.S.
Note
Cisco NCS 4216 Hardware Installation Guide
58
Installing the Cisco NCS 4216
Description
16-port cable for TDM CEM Interface Module, no
redundancy, 10 feet in length
Advertisement
