Cisco NCS 4216 Installing Instruction page 2

Hide thumbs Also See for NCS 4216:

Installing the Chassis Brackets

The Cisco NCS 4216 Door is not displayed in the figures below. It is only displayed in the Installing the

Note

Cisco NCS 4216 Door figure.

Installing the Chassis Brackets

The chassis is shipped with mounting brackets that can be installed on the front or rear of the chassis. To

install the brackets on the front of the chassis, perform these steps:

SUMMARY STEPS

1. Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.

2. Position one of the brackets against the chassis side, and align the screw holes.

3. Secure the bracket to the chassis with the screws removed when performing Step 1 . The recommended

maximum torque is 28 in.-lb (3.16 N-m).

DETAILED STEPS

Step 1

Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.

Figure 1: Attaching Mounting Brackets for a 23-inch Rack

Cisco NCS 4216 Hardware Installation Guide

Installing the Cisco NCS 4216

Table of Contents