Advertisement
Installing the Cisco NCS 4216
SUMMARY STEPS
1. Connect one end of a shielded coaxial cable to the GNSS RF IN port.
2. Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
DETAILED STEPS
Step 1
Connect one end of a shielded coaxial cable to the GNSS RF IN port.
Step 2
Connect the other end of the shielded coaxial cable to the GNSS antenna after the primary protector.
The GNSS RF In port should have a primary protector installed to meet the Local Safety guidelines.
Note
• The GNSS RF In coaxial cable shield must be connected to the Facility Equipment Ground through the chassis.
The chassis must have the ground wire connected to the Facility Equipment Ground.
Figure 19: Installing the GNSS Module in the RSP
1
Screw on the GNSS Module
Connecting a Cable to the GNSS Antenna Interface
2
Cisco NCS 4216 Hardware Installation Guide
Inserting the GNSS Module
55
Advertisement
