Installing The Power Supply - Cisco NCS 4216 Installing Instruction

Hide thumbs Also See for NCS 4216:

Installing the Cisco NCS 4216

Table 2: Supported Hot Swapping Combinations

Interface Modules

SFP Combo IM—8-port Gigabit Ethernet (8X1GE) +

1-port 10 Gigabit Ethernet (1X10GE)

8-port 10 Gigabit Ethernet Interface Module (8X10GE)

1-port 100 Gigabit Ethernet Interface Module (1X100GE)

2-port 40 Gigabit Ethernet QSFP Interface Module (2X40GE)

OC-192 Interface Module with 8-port Low Rate CEM Interface

Module (10G HO / 10G LO)

48 x T1/E1 Interface Module

48 X T3/E3 Interface Module

When you remove or insert a redundant module while the router is powered on and running, the router does

the following:

1 Determines if there is sufficient power for the module.

2 Scans the backplane for configuration changes.

3 Initializes the newly inserted module. In addition, the system notes any removed modules and places those

modules in the administratively shutdown state.

4 Places any previously configured interfaces on the module back to the state they were in when they were

removed.

The router runs diagnostic tests on any new interfaces and the test results indicate the following:

• If the tests pass, the router is operating normally.

• If the new module is faulty, the router resumes normal operation but leaves the new interfaces disabled.

• If the diagnostic tests fail, the router stops operating, which usually indicates that the new module has

To avoid erroneous failure messages, note the current configuration of all interfaces before you remove

Caution

or replace an interface module, and allow at least 2 minutes for the system to reinitialize after a module

has been removed or replaced. This time is recommended in order to allow for synchronization between

components within the interface module and for synchronization with the standby RSP.

Installing the Power Supply

The Cisco NCS 4216 router provides the choice of the following power supply:

a problem in the bus and should be removed.

NCS4216-RSP/Cisco IOS Release 3.18.06v.S

Swapping allowed on all Ethernet interface modules

No support

Cisco NCS 4216 Hardware Installation Guide

Installing the Power Supply

Table of Contents