Cisco NCS 4216 Installing Instruction page 29

Hide thumbs Also See for NCS 4216:

Installing the Cisco NCS 4216

DETAILED STEPS

Step 1

Before inserting an interface module, make sure that the chassis is grounded.

Step 2

To insert the interface module, carefully align the edges of the interface module between the upper and lower edges of

the router slot.

Step 3

Carefully slide the interface module into the router slot until the interface module makes contact with the backplane. The

following figure shows how to install the interface module.

Figure 13: Inserting an Interface Module

Step 4

Tighten the locking thumbscrews on both sides of the interface module. The recommended maximum torque is 5.5 in.-lb

(.62 N-m).

Step 5

Connect all the cables to each interface module.

Installing an Interface Module

Cisco NCS 4216 Hardware Installation Guide

Table of Contents