Sharp EC-A1RAS Operation Manual page 9

hed.
When using the product in the
Do not use any detergent, paint thinner, benzene product
Handy state
or hot water (exceeding approx. 40°C). [Risk of
CAUTION
deterioration or deformation]
Press Release button to remove
Do not apply any hot air, such as air blown by a hair dryer.
respective parts.
[Risk of deformation or product malfunction]
the
port
parts
p) can
Attach
acuum
may
ct
Insert the side without a gear of the Rotary brush,
as far as it goes into the slot.
Lamps notify status of the vacuum cleaner body
Strap the belt on the gear of the Rotary brush and
insert it into the slot.
7
Filter care lamp (red)
on
e.
Battery level indicator
lamp (green)
Contacts (terminals) of charging section
Wipe off any dirt
with a dry cloth.
*1 The Battery level indicator lamp is turned on in following situations. (The lamp is not turned on when there
is no charge left in the battery.)
About 5 seconds after the battery is reinstalled on the vacuum cleaner body.
While using the product for cleaning
About 5 seconds after pressing the
*2 The lamp may also turn on when the Suction head is clogged even when the filter is not dirty.
In such instances, press the
EC-A1RA_Eng_A4(ai sorted).indd
Click!
Release
button
Lamp State
Installation is not
possible when the left Turned
and right are reversed.
on *2
Fast
blinking
Strap on
a belt
Turned on
Blinking
Fast
blinking
Terminal
and then restart operation to turn the lamp off.
6
Always do the following during maintenance:
Press the
remove the battery.
Disconnect the power cord of the Charger from the
electrical outlet.
[Risk of electrocution or injury.]
Tips for making the battery last
Charge the battery every time the product is used,
regardless of how long it was used.
The battery lasts longer when charged before the charge level
becomes low.
Leaving a discharged battery without charging will lead to the
deterioration of the battery.
When the product is not used for a long time
Clip on the tab on the Rotary brush cover in the
Recommended Time for replacing the battery
slot.
About 1,100 times of charge/discharge ◆
According to tests conducted based on Sharp's standard
for repeatedly charging and charge/discharge a battery.
The life of a battery can vary depending on the conditions
of use and the environment.
Rotary brush cover
Slot
Filter care lamp
Slide the Release lever in the direction of
Battery level indicator
the arrow.
Indicated State/ Explanation
Empty the dust cup and clean the filter.
The filter of the Dust cup assembly is dirty.
Clean the filter by rinsing with water.
The filter of the Dust cup assembly is clogged with dust.
The vacuum cleaner body is overheating.
Leave the product in a cool place for a while.
Gear
Operating the product without allowing it to cool leads to the
overheating protection circuit of the vacuum cleaner body triggering,
which disables the product for some time.
There is sufficient charge remaining in the battery.
The charge remaining in the battery is low.
The charge remaining in the battery is quite low.
(There is no charge remaining in the battery.)
Charge the battery. EN-7
and stopping the operation of the product.
Warning
to stop the operation of the product and
EN-4
(red)
lamp (green) *1
EN-13, 14
EN-15, 16
Tab
Slot
EN-18
EN-6
2017/07/21 10:00:55