Sharp EC-A1RAS Operation Manual page 7

Tips SPECIFICATIONS
Power supply
Precautions for Details
Power supply method
Electric power consumption
Continuous operation
There may be cases where the floor surface is damaged when the
time*
roller switch on the bottom side of the Suction head, wheels or
the Napped cushion is worn.
Dust collecting capacity
In the event the part becomes
worn it is necessary to replace it
Charging time
with a new one.
Stop using the product and contact
your nearest service center
Weight
approved by SHARP.
Base unit dimensions
The replacement of the part for the
is performed while the product
charger dimensions
is left with Sharp.
Cord length
Replacement part (Rotary brush
When a single battery is used (fully charged and initial condition of the battery / 20°C).
cover) is available for purchase.
Conditions may vary depending on the material of the floor surface, environment in which the product
is used and the condition under which the product is used.
Do not suction any of the following types of items
INSTRUCTION MANUAL FOR BATTERY PACK ( BY-5SB )
(Risk of scratching of the product interiors and clogging of the
product, as well as product malfunction).
Liquid or moist dirt.
" Disposal method and Storage method "
Sharp objects (glass, razor blade and the like).
Large dirt or a large amount of dirt suctioned at the same time.
Clean respective filters when fine powder (plaster, cement,
Dispose of used batteries according to local ordinances and/or regulations.
chalk and the like) has been suctioned.
After extended periods of storage, it may be necessary to charge and
Do not operate the product while the Dust cup assembly
has been removed.
discharge the cells or batteries several times to obtain maximum
This product is for indoor use only.
performance. Do not store cells or batteries haphazardly in a box or drawer
Do not hit the Suction head hard on the steps on the
floor surface or gaps in floor heights, as well as
where they may short-circuit each other or be short-circuited by other metal
furniture or wall (Risk of the floor surface becoming
objects. Keep cells and batteries clean and dry.
scratched).
Do not apply lubricant to the Rotary brush (Risk of
Replace only with same SHARP Corporation type BY-5SB battery pack.
plastic parts cracking).
Do not drag the charger (Risk of scratching on the floor
surface).
" Charging Information "
Replacing Battery
Item
Batteries are consumable products.The operating time
gradually becomes shorter as the battery deteriorates with
Charging Current (Std.)
repeated use. Although the deterioration of batteries vary
depending on the condition of use or operating
environments, the battery should be replaced if any of the
following conditions apply.
Charging Voltage (Std.)
When the operating time is extremely short even when the battery
has been charged.
Charging cut current
When the Charging lamp (red) of the charger blinks slowly
whenever charging in an environment with room temperature of
between 5°C and 35°C.
We invite you to recycle the spent battery.
The battery (lithium-ion battery) is a precious resource that can be recycled.
Bring in the spent battery to a store that accepts batteries for recycling, rather than disposing of
Battery Pack Model Maximum Charge Current, A
them as waste material.
Information on handling of spent battery.
BY-5SB
Insulate the terminal sections using plastic tape or the like that are available on the market.
Furthermore, do not disassemble the product.
EC-A1RA_Eng_A4(ai sorted).indd 4
Input 100 - 240 V 50-60 Hz (charger)
Rechargeable type (lithium ion battery, 18V
While charging: Approx. 40 W; After charging: Approx. 0.5 W
High mode: Approx. 8 minutes
Standard mode: Approx. 30 minutes
0.13 L
Approx. 80 minutes (charging may take up to maximum of
Wheel
about 2 hours depending on the conditions of use, such as
the surrounding temperature or duration of use)
Roller
Switch
1.5 kg (Suction head, pipe, base unit and battery included)
0.6 kg (charger)
222 mm W x 220 mm D x 980 mm H
Napped cushion
200 mm W x 90 mm D x 133 mm H
Integrated with
Suction head
80 cm (charger)
Napped cushion
Integrated with
Rotary brush
cover
Twines A large amount of sand.
EN-15 and 16
Nominal Specifications
Specifications
1.95A
3.90A
20.75V
20.25V
100mA
Charge Limits
Maximum Charge Voltage, V
3.9A(0～10℃)
7.8A(10～60℃)
When the product is not
used for a long time.
)
Remove the battery from the base
unit and completely charge the
battery before storing.
It is recommended that the power
plug of the charger be removed from
the power outlet.
The charger consumes about 0.5 W
of power while the power plug is
connected to the power outlet.
Removing the power plug when the
charger is not in use can keep down
wasteful power consumption.
Consider following precautions
when storing the battery.
Do not transport or store the product
together with any metal object, such
as a needle, necklace or hair pin.
Furthermore, store the product in a
location where there is little humidity
or dust.
(Risk of heating, ignition of fire or
electrocution.)
EN-5
There are instances where the operation of the
product causes noise to appear on the screen of
television sets. There is no negative impact on
the television set when this occurs.
This cordless vacuum cleaner is intended for
household use and must not be used for commercial
applications. Furthermore, the product must not be
used for any purpose other than cleaning.
Remark
0～10℃
Recommended time for replacing
10～60℃
EN-6
the battery.
0～45℃
There is no malfunction if the the Charging lamp (red) on
45～60℃
the charger blinks slowly when charging in an
environment with a low temperature (about 5°C or lower)
0～60℃
or a high temperature (about 35°C or higher).
Charge the battery in an environment that is between
5°C to 35°C.
20.87V
Terminal
EN-7
EN-20 EN-4
2017/07/07 11:43:17