Sharp EC-A1RAS Operation Manual page 13

Tips for Vacuuming
Emptying the Dust Cup
1
Remove the Dust Cup and dispose of
the dirt.
Move the Suction head so that it moves
Press the Dust disposal
lightly and glides slowly.
More dirt is suctioned this way than quickly
hook (yellow) on the side of
moving the Suction head back and forth.
the Cover section.
This also prevents scratching of the vacuum
cleaner and the floor surface.
Lift the Cover
section.
Always install the Suction head or an Accessory Suction head when cleaning.
[Risk of scratching of floor surface or product malfunction]
CAUTION
Do not clean while pressing the Suction head hard against the floor surface.
Ensure that no dirt
The wheels and Napped cushions
remains at the bottom
of the Dust Cup.
Moving the Suction head (wheel) sideways or diagonally can result in scratches and markings on
the floor surface.
There are instances where the rotation of the wheels deteriorate due to the entanglement of pet hair and
the like on the wheels. Be sure to clean the wheels often.
2
Remove dirt on the Mesh filters
with a cleaning brush.
The product can be left in the conditions depicted in the diagrams below when pausing
the cleaning operation.
When the dirt is
entangled and does
Resting the
vacuum cleaner not come off
Clean the Dust cup
Hook the holder
assembly.
section onto a
EN-15, 16
table or the like.
When used continuously for long time
Keep the Suction head contacting the floor surface when pausing the cleaning operation.
[Risk of falling or tumbling of the product]
CAUTION
3
Mount the Dust Cup.
Verify that there is nothing in the vicinity of the product that can be damaged easily when standing
the vacuum cleaner body leaned on an object.
Align the protrusion on the Dust Cup and the
Pay particular attention to ensure no infant or pet is allowed to get near the product.
Dust disposal hook (yellow) and insert.
Do not leave the product while leaning on an object.
Dust
disposal
hook
(yellow)
Protrusion
EC-A1RA_Eng_A4(ai sorted).indd 10
②
Cover
section
①
Dust disposal
hook (yellow)
EN-17
Standing state
Hook the holder
section on a chair
or the like.
Mesh filter
Holder
Dust accumulates on the built
section
in Pleat Filter.
Clean this dust out.
EN-15, 16
Click!
Mounting the Dust
Cup Assembly
Install the Dust cup assembly
on the vacuum cleaner body.
Stick state
Put the recessed section on the Dust
For cleaning
floors.
Cup to the hook (blue) on the vacuum
cleaner body
may wear quickly and scratch the floor surface.
EN-17
Securely push in the direction of
the arrow
Click!
Always press the
operation of the product.
Place the product on a flat floor.
The Pleat filter cannot be installed
on the vacuum cleaner body unless
CAUTION
it is installed on the Dust Cup.
The suction power may decline,
abnormal noise may be heard, dirt
may enter into the motor and other
issues may arise that may lead to
product malfunction unless the Dust
cup assembly is securely installed
on the vacuum cleaner body.
The Dust cup assembly cannot be
installed properly on the vacuum
cleaner body unless it is
completely assembled.
Caution is required to
ensure that the Mesh
filters (Upper and
Lower) are not lost
while throwing out dirt
or cleaning.
Handy state
For cleaning
stairs.
Recessed
section
Hook
(blue)
and stop the
EN-10 EN-14
2017/07/07 11:43:19