XA00303F-G
Safety instructions: General
Safety instructions:
Special conditions
Safety instructions:
Installation
18
Position 5 (Scintillator; Measuring Range)
Selected option
FMG60
A-D
G-T
Optional specifications
No options specific to hazardous locations are available.
Observe also XA00304F for the device versions marked with II 2(1) G and II 2(1) D:
Basic specification, Position 1 (Approval) = 6, 7, 8, M.
• Comply with the installation and safety instructions in the Operating Instructions.
• Staff must meet the following conditions for mounting, electrical installation, commissioning and
maintenance of the device:
– Be suitably qualified for their role and the tasks they perform
– Be trained in explosion protection
– Be familiar with national regulations
• Install the device according to the manufacturer' s instructions and national regulations.
• Do not operate the device outside the specified electrical, thermal and mechanical parameters.
• Avoid electrostatic charging:
– Of plastic surfaces (e.g. housing, sensor element, special varnishing, attached additional
plates, ..)
– Of isolated capacities (e.g. isolated metallic plates)
In the event of additional or alternative special varnishing on the housing or other metal parts:
– Observe the danger of electrostatic charging and discharge.
– Do not rub surfaces with a dry cloth.
– Do not install in the vicinity of processes generating strong electrostatic charges.
6
1
Pipe housing
2
Compartment housing
3
Terminal compartment A
4
Terminal compartment B
Description
NaJ-Crystal
PVT
3
2
4
1
Gammapilot M FMG60
A0031753
Endress+Hauser