Kcleaning At The End Of The Work; Lroutine Maintenance - Samoa Larius GHIBLI 26:1 EXT Operating And Maintenance Manual

CLEaNING aT THE END OF
K
THE WOrK
By "cleaning at the end of the work" is meant the cleaning to
carry out in case of use with a different product or if a long period
of storage is foreseen.
• Stop the air supply to the pump.
• Dip the material pumping hose into the washing solvent tank
(check its chemical compatibility with the product being
used).
• Make compressed air flow into the pump. It is advisable to
adjust the air pressure to the minimum value necessary to
its continuous working.
store possible dangerous fluids in proper containers. Their disposal must be performed in accordance with the
regulations in force about the industrial waste goods.
rOUTINE MaINTENaNCE
L
always close the compressed air supply and re-
lease the pressure in the plant before performing
any check or maintenance of the pump.
• Check periodically (and every time the pump is operated
after a long storage) the packing nut is not loosened, causing
otherwise the coming out of the product.
• To tighten the packing nut use wrench supplied (code. 16135).
ED. 08 - 05/2020 - Cod. 150093
• Point the spray gun or the delivery valve at a container and
drain all the product left inside the pump till a clean solvent
comes out.
• Now, stop the air supply to the pump and drain the residual
pressure.
• In case of long inactivity, the operations of sucking and leaving
light mineral oil inside the pumping element are suggested.
The packing nut must be tightened so as to avoid wastes
of product, but not excessively to avoid the seizure of the
pumping piston and the wear of seals. In case of persistent
coming out of product, replace the seals.
• To prevent the product from drying up on the piston rod,
refill the packing nut with lubricant.
• Check periodically the air supply to the pump. Ensure the
air is always clean and lubricated.
Fig. 1L
GHIBLI 26:1 EXT
Key
Code 16135
www.larius.com
9