Crossover Ignition System Operations; Maintenance - Weber SUMMIT 425 Operating Manual

MAINTENANCE

11. Lift and twist the burner assembly slightly to separate
the crossover tube from the burners. Remove the
burners from the cooking box. Figure 14.
12. To reinstall the burners, reverse steps 3 through 11.
CAUTION: The burner openings must be positioned
properly over the valve orifices. Figure 15 (a).
Check proper assembly before fastening manifold in
place. Figure 15 (b).
(a)
Valve
Burner
Orifice
(b)
Separate here
Crossover tube
Figure 14
Figure 15

Crossover Ignition System Operations

If the Crossover Ignition System fails to ignite the Left
burner, light the Left burner with a match. If the Left
burner lights with a match, then check the Crossover
Ignition System.
Check that both the white and black ignition wires are
attached properly. Figure 16.
Check that the Crossover Ignition button pushes the
igniter (button) down, and returns to the up position.
Check to see if the igniter is loose in the frame.
Tighten if necessary; See Step "Install igniter" for
correct procedure.
If the Crossover Ignition System still fails to light, contact
Weber-Stephen Customer Service.
White wire
Black wire
13
Figure 16