Electronic Crossover ® Ignition System Operations; Side Burner Maintenance - Weber Spirit 89320 Owner's Manual

ELECTRONIC CROSSOVER
If the Electronic Crossover ® Ignition System fails to ignite the BURNER 1, light BURNER
1 with a match . If BURNER 1 lights with a match, then check the Electronic Ignition .
• Check that both of the ignition wires are attached at the igniter module properly .
• Check that the Electronic Ignition button is working by listening and looking for sparks
at BURNER 1 .
Replace Battery If Necessary
AAA alkaline battery only.
If the Electronic Crossover Ignition System still fails to light, contact the
®
Customer Service Representative in your area using the contact information on
our web site. Log onto www.weber.com

SIDE BURNER MAINTENANCE

m WARNING: All gas controls and supply valves should be in
the OFF position.
Make sure black wire is connected between the igniter and electrode .
Make sure white wire is connected between the igniter and grounding clip .
Spark should be a white/blue colour, not yellow .
A) Igniter Wire (1)
B) Ground wire (2)
C) Burner (3)
Side Burner Grate
Head Retention Clip
Side Burner Ring & Head
Igniter Electrode
m WARNING: The side burner orifice (4) must be parallel to the
side burner tube opening (5).
24
IGNITION SYSTEM OPERATIONS
®
.
®
◆
Control Knob
Igniter Button
◆
5
mAINTENANcE
4
3
3
1 1
2 2
1 1