Weber Platinum 2200 LP Manual page 9

INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3200
You will need... left work surface, side burner assembly,
four 1/4-20 x 1/2 inch bolts, four nylon washers and a
7/16 inch or adjustable wrench.
Insert the left work surface tabs in the slots to the left of
the cooking box. Figure 12 (a). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 12 (b).
Note: Remove protective covers from tabs of
side burners.
Insert the side burner assembly tabs in the slots to the right
of the cooking box. Figure 12 (c). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 12 (d).
Side burner can only be installed on right side
of barbecue.
(a)
Tabs
View from
left side
(b)
View from left
underside
Platinum Series II 3200
Tabs
View from right
Figure 12
Route the side burner hose so it will not interfere with the
scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 13. Figure 14 shows the quick
disconnect engaged.
(c)
Tabs
Quick disconnect
View from Side burner hose
right side
To LP tank
(d)
underside
9
Male fitting
Manifold side view
Figure 13
engaged
Manifold side view
Figure 14
Figure 15
To side burner
connection
View from right
underside