Weber Platinum 2200 LP Manual page 12

INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3400
(CONTINUED)
Route the side burner hose around the tank panel so it
will not interfere with scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 18. Figure 19 shows the quick
disconnect engaged.
Male fitting
Quick disconnect
engaged
Side burner hose
To LP tank
Manifold side view
Figure 18
Manifold side view
Figure 19
To side burner
connection
View from right
underside
Figure 20
Check that the side burner is properly assembled.
Windshield
Grate
Figure 21
Burner head
WARNING: Set the burner ring onto the burner head
with the slots facing up. Rotate the burner ring until
the four lugs on the burner ring are seated in the four
slots on the burner head. Figure 21 (b).
Note: The burner head has a hole in it that fits over the
igniter electrode.
After this assembly, proceed to step "Install Bottom
Rack" on page 13.
12
(c)
Burner cap
(b)
Lugs
Slots
(a)
Burner base
Burner orifice
Burner ring
Igniter
electrode