Weber Platinum 2200 LP Manual page 8

If you have the Platinum Series II 2200,
continue to step "Install Work
Surfaces" on this page.
If you have the Platinum Series II 3200,
go to step "Install Work Surface and
Side Burner" on page 9.
If you have the Platinum Series II 3400,
go to step "Install Work Surface and
Side Burner" on page 11.
INSTALL WORK
SURFACES
FOR THE PLATINUM SERIES II 2200
You will need...left work surface, right work surface, four
1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16
inch or adjustable wrench.
Insert the left work surface tabs in the slots to the left of
the cooking box. Figure 11 (a). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 11 (b).
Insert the right work surface tabs in the slots to the right of
the cooking box. Figure 11 (c). Slip washers on the bolts
and insert the bolts as shown. Tighten. Figure 11 (d).
Tabs
(a)
View from
left side
(b)
View from left
underside
Platinum Series II 2200
After this assembly, proceed to step "Install Bottom
Rack" on page 13.
8
Tabs
View from right
Figure 11
Tabs
(c)
View from
right side
(d)
underside