Check For Gas Leaks - Weber Platinum 2200 LP Manual

CHECK FOR GAS LEAKS

WARNING
The gas connections of your Weber Gas
Barbecue have been factory tested. We do
however recommend that you leak check all
gas connections before operating your
Weber Gas Barbecue.
Remove the knobs from the control panel. Figure 27.
Use a Phillips screwdriver to remove the screws from the
underside of the control panel. Figure 28.
Stand at the right end of the barbecue. Lift the control
panel off. The side burner or work surface remains
in place.
Figure 27
View from right
underside
Figure 28
Do not use an open flame to check for
gas leaks. Be sure there are no sparks or
open flames in the area while you check for
leaks. This will result in a fire or explosion
which can cause serious bodily injury or
death and damage to property.
WARNING: You should check for gas leaks every time
you disconnect and reconnect a gas fitting.
You will need: a soap and water solution and a rag or
brush to apply it.
Note - Since some leaks test solutions, including soap
and water, may be slightly corrosive, all connections
should be rinsed with water after checking for leaks.
Make sure all burner control knobs are in
the OFF position, including the side burner,
if the barbecue has a side burner.
To perform leak checks: open tank valve by turning the
tank valve handwheel counterclockwise. Figure 29.
15
DANGER
WARNING
Figure 29