Remote Control Explanation - Conceptronic CM3S User Manual

ENGLISH
The remote control is used to control the unit. On the inside cover of this manual you will find a picture of
the remote control. The numbers of the buttons correspond with the table below, to explain each function
of the remote control.
Nr Button
1 POWER ( )
2 R / L
3 TOP
4 MUSIC
5 FILE
6 0 – 9
7 AUDIO
8 SLIDE
9 SLOW
10 A – B
11 REPEAT
12 VOLUME
13 VOLUME
14 BACK
15 , , ,
16 PREVIOUS ( )
17 PLAY/PAUSE
18 REWIND ( )
19 OUTPUT
20 SETUP
21 FAST FORWARD (
22 STOP ( )
23 NEXT ( )
24 ENTER ( )
25 DISPLAY
26 PAGE
27 PAGE
28 MUTE
29 ROTATE
30 DELAY
31 ZOOM
32 TRANS
33 SUB-T
34 VIDEO
35 PHOTO
36 FUNC
37 P / N
38 MENU
39 Power LED

5. Remote Control Explanation

Description
Switch between Media Player Mode or Standby Mode
Change the audio output (Stereo, Mono-L, Mono-R).
Go to the top of the current file list.
Start music playback mode with subdirectories.
Show the 'File Library'.
Numeric selection keys 0-9.
Select or change the audio stream (DVD Playback).
Start a Music-slide-show mode or start video step-play.
Play back slowly.
Play a selected interval repeatedly.
Select a repeat mode.
Increase the volume.
Decrease the volume.
Back to the previous folder.
Move the selection in the main menu.
Switch to previous file or chapter.
Start the playback of a file or DVD-Folder or pause a playback.
Fast Rewind during playback.
Select the Video Output Signal.
Open the Setup menu.
) Fast forward during playback.
Stop playback.
Switch to next file or chapter.
Confirm selection or start playback.
Show file information during playback.
Show the next page with files.
Show the previous page with files.
Mute or cancel mute.
Rotate photos.
Select the slide show (include music-slide-show) interval time.
Zoom in or out (Photos & DVD Playback).
Select a mode of transition during a slideshow or a type of music
equalizer during music playback.
Select or change movie Subtitle (MPEG4 & DVD Playback).
Direct access button to your predefined Video folder.
Direct access button to your predefined Photo folder.
Show the file operations menu.
Select a video system. (PAL / NTSC)
A. Show the 'Device List' or 'File Library'
B. Return to the DVD Menu (DVD Playback).
The Power LED will blink when a button is pressed.
19