Table of Contents
Advertisement
Replacing or Installing Modules, Fan Trays, and Power Supplies
2. Use one of your hands to hold the front of the power supply and place your other hand under the power supply
to support its weight.
3. Pull the module out of the slot and place it on an antistatic surface or inside an antistatic bag.
Step 4
If you are not installing a replacement power supply, cover the empty power supply slot with a blank module.
Step 5
If you are installing a replacement power supply, install, connect, and power up the new power supply as follows:
a) Install the power supply as follows:
1. Hold the front of the power supply with one hand and place your other hand under the module to support its
weight.
2. Turn the power supply 90 degrees so that the release lever is on the upper right front end of the module. Position
and orient the other end of the module at the open power supply slot in the chassis.
3. Slide the handle on the middle of the release lever toward the end of the lever and rotate the lever away from the
front of the power supply. Push the power supply all the way into the slot. See the following figure.
1
Slide and hold the middle handle next to the outer
handle.
2
Fully rotate the release lever away from the front
of the module.
Installing or Replacing a 3-kW DC Power Supply
4
Rotate the lever toward the front of the module.
5
Make sure that the other end of the lever grabs the
front of the chassis to push the module onto the
connectors inside the slot.
Cisco Nexus 9516 ACI-Mode Switch Hardware Installation Guide
75
Advertisement
Table of Contents
