Table of Contents
Advertisement
Installing a Chassis in a Rack or Cabinet
Align the screw holes in the chassis mounting brackets to the screw holes in the vertical mounting rails on the rack or
cabinet. Use a Phillips screwdriver to screw in four M6 x 19-mm or 12-24 x 3/4-inch screws in each of the two chassis
mounting brackets (use a total of eight screws for two mounting brackets).
To adjust the placement of the chassis on the bottom-support rails, use the chassis handles.
Tip
1
Step 9
To reinstall the fabric modules, see
Step 10
To reinstall the fan trays, see
Cisco Nexus 9516 ACI-Mode Switch Hardware Installation Guide
26
Handles used to adjust the
chassis placement.
Installing a Fabric Module, on page 62
t_n95xx_install_fan_tray.xml
2
Installing a Chassis
Four M6 x 19 mm or 10-24
x 3/4 in. Phillips screws that
are used to attach each side
bracket to a front mounting
rail (use a total of eight
screws).
Advertisement
Table of Contents
