Startup / Operation - BOMANN KSE 7805 Instruction Manual

4 4 4 4
6 6 6 6
8 8 8 8
1 1 1 1 Install the power cord so that the appliance can be
easily connected after installation. Slide the appli-
ance into the build-in opening until the stop plate (A)
abuts the furniture.
2 2 2 2 Press the rubber seal between the appliance and
built-in furniture firmly (on the side without hinge).
3 3 3 3 Open the appliance door. Push the appliance side,
which is located opposite the hinges, against the
built-in furniture. Arrange the appliance for a secure,
vertical position, fix it with the supplied screws (S).
4 4 4 4 In consideration of the shown distances, hold the
guide (a) at the top and bottom inside of the furniture
door; mark the positions of the drill holes. After drill-
ing, fix the guide with the screws (S) provided.
5 5 5 5 Insert the cover (c) until it clicks in the guide (a).
6 6 6 6 Fully open the appliance and furniture door and join
them together. Slide the angle (b) in the guide (a)
and mark the drill holes. Remove the bracket and
drill Ø 2 mm holes with about 8 mm distance to the
outer door edge. Put the bracket on again; secure it
with the screws (S) provided.
7 7 7 7 If an aligning of the furniture door is necessary, use
the slot spacing. Check if the door is arranged verti-
cal as well as horizontal, so that a smooth opening
and closing of the door is ensured.
5 5 5 5
7 7 7 7
8 8 8 8 Insert the cover (b) until it clicks on the angle (b).
Startup / Opera

Startup / Operation

Startup / Opera Startup / Opera
Prior to first use Prior to first use Prior to first use Prior to first use
CAUTION: : : : CAUTION
CAUTION CAUTION
After transport, the appliance should be left standing
upright for about four hours before connecting to the
power supply. Nonobservance could lead to malfunc-
tion of the cooling system and causes an appliance
breakdown.
Clean the appliance interior including all accessory
parts. Consider the instructions which we provide in
the chapter "Cleaning and Maintenance".
Starting the appliance Starting the appliance Starting the appliance Starting the appliance
• Connect the appliance to the power supply.
• Operate the temperature control. See also the
section "Settings".
Settings Settings
Settings Settings
Setting [ 0 ] means that the appliance is in the off
state. Turn the temperature control clockwise, start-
ing from this setting; the appliance will turn on auto-
matically.
The power levels [ 1 – 7 ] regulate the different val-
ues of the internal temperature.
Setting 0 Setting 0 Setting 1 Setting 1
Setting 0 Setting 0 Setting 1 Setting 1
Off state Lowest setting
(warmest inside
temperature)
Note that the temperature will change depending on
the ambient temperature, frequency of door opening
and the amount of food in the appliance.
During initial operation, turn the temperature control
to the highest setting first, until the appliance has
reached the desired operating temperature. After-
wards it is recommended to turn the control back to a
21
tion
tion tion
Setting 7 7 7 7 Setting
Setting Setting
Highest setting
(coldest inside
temperature)