Installation - BOMANN KSE 7805 Instruction Manual

Installation

Installation Installation Installation
Conditions for the installation location Conditions fo r the installation location
Conditions fo Conditions fo r the installation location r the installation location
Good ventilation is required around the appliance
-
to dissipate the heat properly and to guarantee ef-
ficient cooling operation at low power consump-
tion. Enough clearance is necessary.
Refer to the instructions which we give you in
-
"Built-in";
Place the appliance so that the appliance door
-
can open without being impeded.
• Only install at a location with an ambient tempera-
ture suitable for the climate class of the appliance.
For information on the climate class, please refer
to the "EU Product Data Sheet" or to the rating la-
bel located in the interior or on the appliance rear.
• Look for stable, horizontal appliance position.
• Avoid the installation: Avoid the installation:
Avoid the installation: Avoid the installation:
near heaters, next to a stove, direct sunlight or
-
any other heat sources;
at locations with high humidity (e.g. outdoors,
-
bathroom), as metal parts would be suscepti-
ble to corrosion under such circumstances;
near volatile or flammable materials (e.g. gas,
-
fuel, alcohol, paint, etc.), in rooms which may
have poor air circulation (e.g. garages).
Do not expose the appliance any weather.
-
Electrical connection Electrical connection Electrical connection Electrical connection
WARNING: WARNING: WARNING: WARNING:
• The installation to the mains supply must conform
to the local standards and regulations.
• Improper connection may cause to an electric
shock! shock shock shock
• Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
• The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
• Make sure that the voltage supply matches the
specifications on the rating label before connect-
ing.
• Connect the mains cable to a properly installed
and earthed wall outlet.
• If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.
Reversing the door opening Reversing the door opening
Reversing the door opening Reversing the door opening
If required, the door opening can be moved from the
right (supplied condition) to the left side.
W W W W ARNING: ARNING: ARNING: ARNING:
When replacing the door stop, the appliance must be
disconnected from the power supply first.
NOTE: : : : NOTE NOTE NOTE
• Ask another person to assist.
You possibly need:
•
driver as well as a thin-blade screwdriver.
electric electric electric
• Dismount the upper door hinge, lift the appliance
door and set the door safely aside.
• Dismount the lower door hinge.
• Place the respective blind caps on the exposed
holes of the upper and lower door hinge.
• Turn over the originally upper door hinge and
install it at the bottom left side.
19
screw wrench, Phillips screw-