The Bar Code Scanner; Chapter 3. Power System; Charging The Lithium-Ion Battery Pack; Charging The Main And Backup Battery For The First Time - Wasp WDT 3200 Product Reference Manual

Wasp bar code scanner product reference guide

Hide thumbs Also See for WDT 3200:

Table of Contents

WDT 3200 Product Reference Guide

The Bar Code Scanner

The WDT3200 has an integrated laser scanner capable of reading all major bar code

labels.

The WDT3200's batteries can be charged via the USB or serial communication

cable, or via the optional docking station - both using the included AC adaptor.

Please charge the battery for at least 4 hours per session to ensure a full charge.

Please note that the first time charge should be for at least 12 hours (see below).

When first charging the WDT3200, please allow at least 12 hours to fully charge

both the main and backup batteries. When the WDT3200 arrives from the

factory the backup battery switch is in the OFF position in order to protect the

backup battery. Before charging the WDT3200, make sure the backup battery

switch is moved to the ON position. The backup battery switch can be found

inside the main battery compartment. Data loss can occur if the backup battery

is not adequately charged - therefore it is imperative to ensure that the backup

battery switch is in the ON position before charging for the first time.

Note: A properly charged backup battery can store data for up to 72 hours

without power from the main battery. This is not recommended. Please make

sure an adequately charged main battery or AC power is connected. Do not rely

on the backup battery for other than unusual or emergency situations. To

prevent data loss due to backup battery failure (always a slim possibility), please

minimize the amount of time that the backup battery has to operate without the

main battery pack installed or while disconnected from AC power.

It is important to consider the temperature when you are charging the Lithium-Ion battery

pack. The process is most efficient at normal room temperature or slightly cooler. It is

Table of Contents

Do you have a question about the WDT 3200 and is the answer not in the manual?