Heat & Glo COSMO32-IFT-B Installation Manual page 65

Inside Fit - CFTF Front
(1 Inch to 6 Inch Thick Finishing Material)
The CFTF is the only approved front for inside fit
applications (fi nish material over 1 inch thick). The CFTF
decorative barrier front can be installed with or without
the outer decorative barrier front trim (included with the
decorative barrier front). See Figure 10.11.
If the desired look is to include the outer decorative barrier
front trim, fi nishing materials up to 1-3/16 around the
fi replace opening. See Figure 10.12. For this installation,
the inner decorative barrier front hangs on four tabs located
on outer decorative barrier front trim. The auxiliary hanging
brackets are not used and may be discarded. See Figure
10.13.
If the desired look is to exclude the outer decorative barrier
front trim, fi nishing material can be installed up to the
fi replace opening. See Figure 10.14. For this installation,
the inner decorative barrier front hangs on four tabs located
on the auxiliary hanging brackets. The outer decorative
front trim is not used and may be discarded. See Figure
10.15.
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
Figure 10.11 Maximum Finish Material Thickness - CFTF
Decorative Barrier Front
Heat & Glo • COSMO32-IFT-B, COSMO36-IFT-B, COSMO42-IFT-B Installation Manual • 2619-980 Rev. G • 7/20
FINISHING MATERIAL
6 IN. MAXIMUM THICKNESS
CFTF Decorative Front
Non-Combustible Finish Material 1-6 Inches Thick
1-3/16 IN.
Figure 10.12 Clearances to Appliance Opening With Outer
Decorative Barrier Front Trim
TABS (4)
TOP VANITY PANEL
(NOT SHOWN)
Figure 10.13 CFTF Front Installation With Outer Decorative
Barrier Front Trim
1-3/16 IN.
1-3/16 IN. (CFTF)
OUTER DECORATIVE
FRONT TRIM
INNER DECORATIVE
FRONT ASSEMBLY
65