Table of Contents
Advertisement
Available languages
Available languages
INSTALLATIoN
Commissioning
Wall mounting bracket for appliance replacement
An existing Stiebel Eltron wall mounting bracket may be used
when replacing appliances (except instantaneous water heater
DHF).
f Break through the back panel of the appliance for the thread-
f
ed stud on the pre-installed wall mounting bracket.
DHF replacement
f Reposition the threaded stud on the wall mounting bracket
f
(the stud has a self-tapping thread).
f Rotate the wall mounting bracket 180° and mount it on the
f
wall (the DHF logo is then turned towards the reader).
Installation with offset tiles
20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance and lock the back panel with the
f
fixing toggle by turning it clockwise through 90°.
Operation with preheated water
By installing a central thermostatic valve you will limit the max-
imum inlet temperature (see chapter "Appliance description /
Accessories").
28
| DHE SL LABS
10. Commissioning
WARNING Electrocution
Commissioning may only be carried out by a qualified
contractor in accordance with safety regulations.
10.1 Initial start-up
f Open the cross-piece.
f
on
on
f Open and close all connected draw-off valves several times,
f
until all air has been vented from the pipework and the
appliance.
f Carry out a tightness test.
f
f Activate the safety switch (AE 3) by firmly pressing the reset
f
button (the appliance is delivered with the safety switch
deactivated).
f Fit the appliance cover and secure it with a screw.
f
f Switch the mains power ON.
f
f Check the function of the appliance.
f
f Remove the protective foil from the control fascia.
f
Appliance handover
f Explain the appliance function to users and familiarise them
f
with its operation.
f Make users aware of potential dangers, especially the risk of
f
scalding.
f Hand over these instructions.
f
www.stiebel-eltron.com
Advertisement
Chapters
Table of Contents
Troubleshooting
