Table of Contents
Advertisement
Read the following important safety information before using this equipment to avoid serious injury or death and
to avoid damage to equipment or property.
WARNING
ELECTRIC SHOCK HAzARD:
• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Units supplied without an electrical cord and plug
require a hardwired connection to the on-site electrical
system. Connection must be properly grounded and of
the correct voltage, size, and configuration for the
electrical specifications of the unit. Contact a qualified
electrician to determine and install the proper electrical
connection.
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void the unit
warranty and may lead to electric shock or burn, as well
as damage to unit and/or its surroundings.
• Turn power switch OFF, unplug power cord/turn off
power at circuit breaker, and allow unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate unit indoors where
ambient air temperature is a minimum of 70°F (21°C).
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use jet-
clean spray to clean this unit.
• Discontinue use if power cord is frayed or worn.
• Do not attempt to repair or replace a damaged power
cord. The cord must be replaced by Hatco, an
Authorized Hatco Service Agent, or a person with
similar qualifications.
• This unit must be serviced by a licensed electrician.
Service must conform to all local electrical codes.
Service by unqualified personnel will void the unit
warranty and may lead to electric shock or burn, as well
as damage to the unit and/or its surroundings.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
Form No. TFWMM-0810
IMPORTANT SAFETy INFORMATION
FIRE HAzARD:
• For corded units: To reduce the risk of fire, the
appliance is to be installed in non-combustible
surroundings only, with no combustible material within
18" (457 mm) of the sides, front, or rear of the appliance
or within 40" (1016 mm) above the appliance. The
appliance is to be mounted on floors of noncombustible
construction with noncombustible flooring and surface
finish and with no combustible material against the
underside, or on noncombustible slabs or arches have
no combustible material against the underside. Such
construction shall in all cases extend not less than 12"
(305 mm) beyond the equipment on all sides.
• For hardwired units: Do not install closer than 3"
(76 mm) from any side wall. Install only over a non-
combustible surface, see installation instructions.
• DO NOT use paper or plastic serving pieces in the food
finisher. These materials may melt or burn causing a
fire hazard and/or food contamination and may damage
the unit.
ExPLOSION HAzARD: Do not store or use gasoline or
other flammable vapors or liquids in the vicinity of this or
any other appliance.
Make sure all operators have been instructed on the safe
and proper use of the unit.
This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them away
from the unit.
This unit has no "user-serviceable" parts. If service is
required on this unit, contact an Authorized Hatco Service
Agent or contact the Hatco Service Department at 800-558-
0607 or 414-671-6350; fax 800-690-2966; or International fax
414-671-3976.
BURN HAzARD:
• Some exterior surfaces on unit will get hot. Avoid
unnecessary contact with unit.
• Plate/tray will be very hot upon removal — use oven
mitt, protective clothing, or pan gripper to remove.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
DO not use "Pyrex" glass plates or serving pieces in food
finisher. "Pyrex" glass may break causing personal injury
and/or food contamination.
Do not place anything on top of unit; doing so may subject
personnel to injury or could damage unit.
Transport unit in upright position only. Failure to do so may
result in damage to unit or personal injury.
3
WARNING
CAUTION
Advertisement
Table of Contents
