Options And Accessories - Hatco THERMO-FINISHER TFWM Series Installation And Operating Manual

OPTIONS AND ACCESSORIES

Countertop Conversion Kit
The countertop conversion kit allows the wall mounted food
finisher to be installed on a countertop. Components of the kit
include a rear panel and four 4" (102 mm) legs . Use the
following procedure to install the kit.
1. Install the rear panel, if it is not already. To install:
a. Make sure the wall brackets are hooked over the 1/2"
hanging rods on the back of the unit.The brackets should
be pushed against each end of the unit to align with the
rear panel mounting holes.
b Position the rear panel on the back of the unit. Align the
four holes on the rear panel with the holes on the wall
brackets on each end of the unit. Readjust the position
of the wall brackets, if necessary.
c. Thread the four rear panel screws through the rear panel
and into the wall brackets. Tighten securely.
NOTICE
Do not lay unit on the side with the control panel or damage
to unit could occur.
NOTE: Additional help may be needed to maneuver the unit to
the proper position for installing legs.
2. Carefully position the unit with the control panel facing up.
3. Attach the four legs by turning the legs clockwise into one
of the threaded holes in each of the four corners on the bot-
tom of the unit. Tighten the legs securely.
4. Return the unit to the upright position and move it to the
desired operating location.
Figure 10. Leg Installation
4" Leg
12
Form No. TFWMM-0810