Inhouse:reg_Enable - VXI VM4016 User Manual

INHOUSE:REG_ENABLE

The INHOUSE:REG_ENABLE command controls the masking for REGINT. REG_ENABLE 0
means that backplane interrupts cannot be generated. If the REG_ENABLE is 1, then backplane
interrupts can be generated. If PSEUDO is set, then a write to the register at offset 0x38 also
controls the masking. Enable or disable capabilities are provided in the pseudo register interface to
allow a complete register interface. It is important to note that all letters of the command must be
provided as there is no short form for this command.
INHOUSE:REG_ENABLE <boolean>
EXAMPLES
INHOUSE:REG_ENABLE 1
INHOUSE:REG_ENABLE?
1
INHOUSE:REG_ENABLE 0
INHOUSE:REG_ENABLE?
0
24
VXI Technology, Inc.
Where <boolean> is 0 | OFF | 1 | ON.
Enables the REGINT type interrupt
generation
Returns 1 to state that backplane
interrupting is currently enabled.
Disabling REGINT interrupt generation.
Returns 0 to state that backplane
interrupting is currently disabled.
VM4016 Programming