Advertisement
ICWUSA.com, Inc.
ATTACH VESA
TO MONITOR
Using a phillips
screw driver,
attach the VESA
plate to the back
o f y o u r L C D
monitor.
ADJUST
PARALINK TILT
Adjust Monitor to desired
position with ball VESA.
Tilt your monitor 50°
in any direction. Adjust
your monitor between
portrait and landscape
by rotating ball VESA.
Adjust monitor depth
by moving the paralink
forward or back then
t i g h t i n g t h e d e p t h
adjustment knob.
ATTACH ELITE
ARM COVERS
TOP COVERS:
Attach the long arm
cover by screwing the
two 1/4" long 6-32
fl athead screws in the
center of the cover
using a philips head
screwdriver.
NOTE: DO NOT USE
POWER TOOLS TO ATTACH.
DO NOT OVER TIGHTEN.
IF COVER IS BEING
DISTORED, SCREW HAS
BEEN OVER-TIGHTENED
page 3
ELITE DOUBLE ARM
ATTACH KEYBOARD TO MONITOR
Attach
Keyboard Mount to
the
by using the 3/8-16
screw and lock washer
provided
ATTACH PARALINK KEYBOARD TRAY
Attach the keyboard tray
to the Keyboard Mount
using the supplied 5/16-
18 socket head screw.
Depth
Adjustment
Knob
CENTER COVER:
Attach the center
cover by screwing
the four 3/4" long
10-24 fl athead
screws using
a philips head
screwdriver.
END COVERS:
Attach the
end covers by
screwing the
two 3/4" long
10-24 fl athead
screws using
a philips head
screwdriver.
If you have any questions, please call 1-800-558-4435
the
Paralink
Monitor
Mount
Loosen knob to adjust Paralink.
Adjust horizontally for keyboard tray
and vertically for monitor. Tighten
knobs when in desired position.
ADJUST BALL VESA
TENSION & HEIGHT
Use the slider knob to
loosen the slider to adjust
the height of the monitor
on the Paralink.
Adjust the pivot tension
of the ball by gently and
e v e n l y t i g h t e n i n g o r
loosening the four screws
on the back of the ball
VESA.
ADJUST ELITE ARM RESISTANCE
ELITE DOUBLE ARM INSTRUCTIONS - rev 11/01/2013 mf
Slider Knob
Pivot tension
adjustment
screws
Extend the Elite straight out
as shown before adjusting
the arms' resistance. Be sure
all equipment is mounted on
the arm before adjusting.
Adjust the arm closest to
the monitor fi rst. Use the
T-handle provided to adjust
the arms' resistance. Do not
use power tools to adjust.
Advertisement
