Advertisement
ICWUSA.com, Inc.
REMOVE ELITE
ARM COVERS
TOP COVERS:
Remove the
long arm cover
by unscrewing
the two 1/4"
long 6-32
fl athead screws
in the center of
the cover using
a philips head
screwdriver.
IF YOU ORDERED THE ROTATION LIMITER ACCESSORY
ADJUST ROTATION LIMITS - WALL MOUNT
MANAGE CABLES THROUGH ARM
Extend the arm straight out and
lay all the cables for your monitor,
keyboard
channel on top of the arms.
page 2
ELITE DOUBLE ARM
CENTER COVER:
unscrewing the two
head screwdriver.
The rotation limits for
the arm are set by
placing the stop pins in
the hole corresponding
Stop Pin
to where you want the
arm to stop. The stop
pin then collides with
the stop block on the
front of the wall mount
ear, stopping the arm.
The stop pins can be
removed and set by
hand.
and
mouse
in
the
NOTE:
YOU
LEAVE SOME SLACK IN
THE CABLES TO ALLOW
FOR ARM MOVEMENT.
If you have any questions, please call 1-800-558-4435
ATTACH ELITE ARM TO WALL MOUNT
Remove the
center cover by
unscrewing the
four 3/4" long
10-24 fl athead
screws using
a philips head
screwdriver.
END COVERS:
Remove the
end covers by
Bearing
assembly
3/4" long 10-24
fl athead screws
using a philips
5mm
Lay cables evenly around
adjuster with wire loom
MUST
Add provided wire clips,
weaving through wire loom
to secure cables.
ELITE DOUBLE ARM INSTRUCTIONS - rev 11/01/2013 mf
9/16 wrench
(provided)
Pass 3/8 bolt with bearing
assembly through wall
mount ear and into end
of Elite Arm. Secure Elite
Arm over wall mount
using split lock washer
and nylock nut with 9/16
wrench
5mm hex key.
Black plastic beauty cap
Stop Pin
Wire tie cables around
adjuster, securing the
cords and the wire loom.
on each side.
Add wire clips to end
provided
and
Stop Block
Leave some slack.
of arms as well.
Advertisement
