Advertisement
Drilling the Front Support
1. Once the tower is in the "air" you will need to mark the 2 holes that you will have to drill in the
front support. Use a 9mm drill bit or a 23/64 drill bit.
2. Use a sharpie to mark the holes on both sides.
3. Disassemble the front support apart to drill the holes.
4. Once drilled put the support back together and bolt it.
Drilling the Top Section
1. Once the tower is "up" mark the hole and drill them with a 3/8 drill bit
2. The FreeRide tower has parts # 24 which is the integrated nut.
3. Part #23 is the integrated speaker clamp.
Wiring
Advertisement
