Advertisement
2. If you have an over head garage or tree you might be able to use it to take up the weight.
3. This will help determine where the tower will fit on you boat. Remember to check the under
side prior to drill for wires, also make sure you have access to that area.
4. Once you have a general area for the rear tower feet, go a head and make some marks.
5. You will need to measure to make sure that you have the tower feet in the same place side to
side.
6. As a note some times cleats are not in the same place on your boat.
Drilling for the Rear Feet
1. Once you have marked your 4 holes, check the underside for wires.
2. If necessary, you should move the wires out of the way while you drill. We recommend drilling a
small pilot hole which will keep the 5/8" drill bit from walking (moving). A small rat tail file can
be used to ease the edge and keep the gel coat from chipping. Be careful of wires!
Advertisement
