Bosch EasyGrassCut 18 Original Instructions Manual page 28

28 | English
Edge cutting
Guide the trimmer along the edge of the lawn. Avoid contact
with solid surfaces or walls to prevent rapid wear of the cut-
ting line.
Cutting around trees and bushes
Carefully cut around trees and bushes so that they do not
come into contact with the cutting line. Plants can die if you
damage the bark.
Dismounting the spool, winding up the cutting
line and mounting the spool (see figures J to L)
Remove the battery before replacing the spool.
u
Press both latches of the spool cover together and remove
the spool cover (11). Afterwards, remove the empty spool
(12).
Troubleshooting
d.c.
Lawn Trimmer/Lawn Edge Trimmer
Problem Possible Cause
Motor refuses to start Battery discharged
Battery too hot/cold
Garden tool functions On/Off switch defective
intermittently
Internal wiring of garden tool defective
Garden product la- Grass too high
bours
Garden tool does not Cutting line too short/broken off
cut
Spool empty
Cutting line can no Line inside the spool entangled
longer be fed
Spool empty
Cutting line retracts Cutting line too short/broken off
into spool
Cutting line breaks fre- Line inside the spool entangled
quently
Trimmer used incorrectly
Heavy vibrations Cutting line broken
Cutting system damaged
Grass between spool housing and line-feed but-
ton
Grass in hole for line feed
Battery and charger
F 016 L94 030 | (04.06.2020)
Cut off approx. 4.0 m line from the refill roll. Slide one end of
the cutting line into the hole for line wind-up (13) in the
spool and wind up the cutting line uniformly and tightly.
Slide the other end of the cutting line through the hole for
line guiding (14) in the trimmer head and mount the spool
back into the trimmer head. Affix the spool by mounting the
spool cover (11).
Line Feeding (see figure M)
Semi-automatic Line Feeding
The trimmer is equipped with a semi-automatic feeding sys-
tem. The system feeds 10 mm of the line with every press of
the on/off switch (4).
Manual Line Feeding
Press the line-feed button (15), and pull the cutting line out
to the desired length.
Corrective Action
Recharge battery
Allow to cool/warm
Contact Bosch customer service agent
Contact Bosch customer service agent
Cut in stages
Manually feed cutting line
Replace line spool
Inspect the spool, rewind if necessary
Refill line spool
Remove spool – rethread line (see figures J − L)
Remove spool – rewind line (see figures J − L)
Only trim with the tip of the line, avoid stones,
walls and other hard objects. Feed the line regu-
larly to maintain full cutting diameter.
Pull out cutting line with manual feed (see figure
M)
Contact Bosch customer service agent
Disassemble spool cover and remove grass
Remove grass from hole for line feed
Bosch Power Tools