Bosch EasyGrassCut 18 Original Instructions Manual page 26

26 | English
Noise/Vibration Information
Noise emission values determined according to EN 50636-2-91.
Typically the A-weighted noise levels of the product are:
– Sound pressure level
– Uncertainty K
– Sound power level
– Uncertainty K
Vibration total values ah (triax vector sum) and uncertainty K determined according to EN 50636-2-91
– Vibration emission value a
h
– Uncertainty K
Mounting and Operation
Action
Product features
Delivery scope
Removing the transport safety
Connecting the shaft
Adjusting the handle
Mounting the protection guard
Battery charging and inserting
Switching On and Off
Switching from lawn trimming/
edge cutting
Removing the line spool
Winding line on spool
Mounting the line spool
Line feeding
Maintenance, Cleaning and Stor-
age
Accessories
Assembly
Caution: Switch the garden tool off and pull the mains
u
plug before performing any maintenance.
Connect shaft (see figures C and D)
Note: A connected shaft can no longer be dismounted.
Remove the transport safety (9).
Connect the individual parts of the shaft until they can be
heard to engage.
Mounting and adjusting the handle (see figure E)
The handle (1) can be set to different positions. To change
the adjustment, press buttons (7) and move the handle to
F 016 L94 030 | (04.06.2020)
dB(A)
dB
dB(A)
dB
2
m/s
2
m/s
the desired position. Release the buttons (7) again so that
the handle can engage.
Figure Page
Mounting the protection guard (see figure F)
446
A
Before mounting the protective guard, pull the plant-protec-
B 447
tion frame from the delivery position to the storage position.
C 447
Position the protection guard (8) on the trimmer head and
fasten it with the provided screw.
D 448
Do not disassemble guard once connected.
E 448
Then, pull the plant-protection frame to the working posi-
F 449
tion.
G 450
H 450
Switching on
I 451
Caution: Switch garden tool off and remove battery
u
from machine before adjusting or cleaning.
J 452
The cutting line continues to rotate for a few seconds
u
K 452
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching on again.
L 453
Do not briefly switch off and on again several times in
u
M 453
a row.
N 454
Only use Bosch approved cutting elements. Cutting
u
performance will vary with different cutting elements.
O 455
Charging the Battery
The battery is equipped with temperature monitoring that al-
lows charging only in the temperature range between 0 °C
and 35 °C. In this manner, a high battery service life is
achieved.
Note: The battery is supplied partially charged. To ensure
full battery capacity, completely charge the battery in the
battery charger before using for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging procedure
does not cause damage to the battery.
The "Electronic Cell Protection (ECP)" protects the lithium-
ion battery against deep discharging. When the battery is
empty, the product is switched off by means of a protective
circuit: The product no longer operates.
3 600 HC1 A..
72
= 2.5
82
= 1.0
< 2.5
= 1.5
3 600 HC1 C..
74
= 2.5
85
= 1.0
< 2.5
= 1.5
Bosch Power Tools