lopital Elexo Instructions For Use Manual page 37

• Once the charger is connected to the Elexo, the controls will go into 'sleep' setting
(all functions are switched off).
Make sure that you push the plug into the correct position in the charging
point.
Only the original charger for the Elexo may be used. If you use another
charger, Lopital cannot be held liable for any consequences, such as damage
to the electronics.
Once the charger is connected to the Elexo, the controls will go into 'sleep'
setting (all functions are switched off).
The charger that must be used for the Elexo is the 'Mascot 2241'.
• When the indicator light on the charger goes green, the battery is charged.
The charger can remain connected even when the battery is completely charged.
Leaving it connected will not cause any damage.
• Disconnect the Elexo from the charger.
• Once activated, the Elexo is now ready for use (See paragraph 2.2. Activating).
LED not on:
Green LED is on:
Orange LED is on:
Orange LED blinks:
Red LED blinks:
Red LED on:
Charge battery in a well-ventilated, dry space.
After using the chair, connect it to the charger to maintain the battery.
Charge the chair at least once a week!
For instruction videos go to www.lopital.com or www.youtube.com/user/LopitalNL
Chair is in 'sleep' setting and cannot
be used.
Chair is ready for use.
Battery needs charging or battery is
partially charged.
Emergency stop has been activated.
Battery must be charged (chair can still be used).
Battery is completely empty and must be charged immediately.
Elexo Shower-toilet chair | Instructions for use | 37
Figure 22 Battery indication
on manual control.