IDEC HG2F-SS22VF Manual page 17

4. Description of the Program
(2) When the "Bit Write Command" dialog box is displayed,
configure the Trigger Condition settings first.
(3) Select "While satisfying the condition"
in the Trigger Type field.
(4) Click the [...] button on the right of the
Condition field to open the "Trigger Condition
Settings" dialog box and configure the
settings as shown below so that the bit write
command is executed when "LKR100"
matches "LDR8010".
After configuring the settings, click the [OK]
button. The specified mathematical formula is
stored in the Condition field.
(5) Select the "General" tab and select the Destination
Device. Set the parameter to "LDR100-0" here.
(6) Click the [OK] button to
complete the settings.
(7) Compare each of LDR8011 to LDR8016 with each of LKR101 to LKR106 using the above procedure,
and specify the respective comparison results as LDR100-1 to 6.
17